Gear stick

[zaa]

[color=#000000:post_uid0]ANY SUGGESTIONS ON HOW TO REDUCE THE SIZE OF THE GEAR STICK OR IS AS EASY AS CUTTING IT WITH A HACKSAW
AND FINDING A GEAR NOB THAT DOES NOT THREAD ON.[/color:post_uid0]

[BigMal]

[color=#000000:post_uid1]To do it properly you need to add on the bottom and cut
from the top. *Don't use a hacksaw and take off the thread
as that will cause heaps of problems with getting knobs to
secure properly. *Take the time to take the shifter out an
have it cut and welded properly. *If you just cut from the
top you it is not a quickshift you need the extra length on
the bottom to do that.

Regards

Mal[/color:post_uid1]

[BigMal]

[color=#000000:post_uid1]Here's some photo's of what was done by someone else and
also a aftermarket shifter.

[img:post_uid1]http://groups.yahoo.com/group/Astina/files/Short%20Shifter%20Kits/Astinashifter1.jpg[/img:post_uid1]

http://groups.yahoo.com/group....ter.jpg (http://groups.yahoo.com/group/Astina/files/Short%20Shifter%20Kits/Astinashifter.jpg)

Regards

Mal[/color:post_uid1]

[Toyboy]

[color=#000000:post_uid14]Well i cut off my thread on mine and tapped a new thread onto it,and it works fine :p[/color:post_uid14]

[..::TalenT::..]

[color=#000000:post_uid3]so mal, to create a quickShift you need to add some to the stick under the ball?

thanks, adam :cool:[/color:post_uid3]

[..::TalenT::..]

[color=#000000:post_uid5]ooo i see that pic didnt load the first time i looked at the page ... hmm thats not a bad idea hey... does it make much of a difference like a noticible difference ??

thanks adam :cool:[/color:post_uid5]