View Full Version : BPT compression ratio?
Rupewrecht
25-04-2003, 10:35 PM
It's late, i have a cold and i have to get up at 6am. grr
But anyway, what i need to know is what the standard compression ratio is for the BP26 (GTX) engine? and for the BPD (GTR)?
as with all the work that's being done to my engine, it's changed the cr from what it was with the old pistons...and i'd like to know if there's any difference, as i can basically choose what i want with the headwork thats about to be done
cheers
Dan
7.9:1 for the GTX
8.2:1 for the GTR
If the source is correct.
Rupewrecht
26-04-2003, 02:04 PM
ahah sweet Jimbo - where'd you get them from? just curious, that's all
hmm i would have expected the GTR one to be about the same...
might pick a happy medium and go for about 8.1:1
Some site i found selling the motors via google. I didnt save the address and thought about bookmarking it just after i shut the window.
My Bad.
Rupewrecht
26-04-2003, 02:22 PM
no probs, i'm sure i can find it myself - just couldn't be bothered last night :roll: :lol:
BigMal
27-04-2003, 03:00 PM
From memory out of my TX3 manual (Its with the Mechanic so cant look)
the GTX/TX3 motor is 8.2/8.3. If you are running more boost lower
would be better, but the offset is loss in off boost performance. The lower
the CR the more air/fuel that you can put into the cylinder before
problems with detonation etc from very high compressed pressures.
Wouldn't go much lower than 8:1 on a street car thou.
Regards
Mal
Rupewrecht
30-04-2003, 12:49 PM
okay, found on a few sites (including this one which is pretty much gospel about GTRs) that the GTR CR is 8.2:1
and i'm going to go with that :)
and yeah, i agree Mal - but i wasn't sure what it was as standard :)
Rupewrecht
02-05-2003, 10:20 AM
BANZAI!!!!
MrShadow
02-05-2003, 10:25 AM
You two referring to that "Banzai" show that was on a while ago? Wish I'd seen it, had the guy at work telling me 'bout it. Anybody tape it?
vBulletin® v3.8.7, Copyright ©2000-2024, vBulletin Solutions, Inc.