bar mods

[astina]

hey all just wondering how hard it would be to put indicator holes in an aftermarket front bar as the one im looking at dosent have them.
thanks

[Trav]

I have an angle grinder :P

Not that difficult. Just cut bar to reqired shape. You may need to plastic weld/glue some brackets in at the back to hold the lights though...

[JynX]

Angle grinder... jesus....

Dremel for the more accurate :)

[Trav]

Angle grinder... jesus....

Dremel for the more accurate :)

I was only kidding abou the Angle grinder....but i spose it did work wonders on dans car... :twisted:

[Rupewrecht]

vzzzzzzzzzzzzzzzzz *clunk* vzzzzzzzzzzzzzzzzz *clunk*

it depends how you want to do the indicator holes. if you just want to stick the lights directly behind the front bar (hard up against the inside) you coiuld just cut a hole, and sand the edges smooth. But if you want to inset it a little, you might have to learn to fibreglass!