Go Back   AstinaGT Forums > SP BLING

Conversation Between SP BLING and konman
Showing Visitor Messages 1 to 1 of 1
  1. konman
    28-03-2010 08:23 PM
    konman
    Hi
    Ive read through your post about your BP astina rebiuld. Nice job incidentally.

    I have a question, and would be greatfull if you helped. I am currently stripping the exact same model, and gone as far as taken the cams out, and stripped the piping and electrical from the head section of the motor. My plan is to take off the head to replace the headgasket, or recon the head.

    Im having trouble with the engine mount on the left side, and wondering how you took that off. THere is a large bold on the rear side of the engine, underneath the intake plenum which holds the mount on. How did you take this off? and with what tool? I currently only have a standard socket set with ratchet and nothing else. Would i need a universal jointed ratchet to get at that right angle?

    Also to access the timing belt, how did you get the pulleys off the water pump? seems very tight down there.

    Thanks a million

    Kon

All times are GMT +10. The time now is 07:37 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
2001- 2010 AstinaGT