View Single Post
Old 21-12-2007, 01:14 PM   #79
Aliano
Junior Member
 
Join Date: Dec 2007
Location: toowoomba
Car: Mazda eunos
Posts: 5
Hi,
I'm new to the Mazda engine swaps, I have just purchased an eunos 500
complete with cooked engine (2.0L) and have also purchased a 2.5 mx6
import engine from Rolin Imports of the KL variety, which should give it some get up and go. I have been asured by Rolins that it will fit straight in. If anyone can give me some info on taking the motor out eg: engine and tranny together, engine by itsself, from under the car or will it come out from the top? I have changed plenty of rear wheel drive car engines and done clutch's on front wheel drive cars but haven't done a complete engine change on one as yet, so any suggestions to make it easier would be greatly appreciated.
Thanks.
Aliano is offline   Reply With Quote