View Single Post
Old 01-09-2016, 08:38 AM   #49
Mad Mat
HONEYWELL REPRESENT
 
Mad Mat's Avatar
 
Join Date: Aug 2005
Location: Salisbury - Inner City
Car: 1997 BA Hardtop - Had a 2003 BJii J48 Sport20, and 2x bg SOHC astina hatches
Posts: 5,011
Send a message via MSN to Mad Mat
Troy (2xs) does some great work.. he built my new manifold, ic piping and dump pipe from scratch

Quote:
Originally Posted by BG1.8sp View Post
New turbo, manifold and dump pipe has been sorted.

Have gone with another 2xs tubular steam pipe manifold.
This one is twin scroll t3 divorces flange, '
with 2x tial 38mm external gates.

Dump pipe is again, another 2xs one, with 3" V-band outlet, and 2x v-band plumb back ports for the external gates.

Turbo is Garrett GTX3076, with Garrett Ni-resist T3 Divorced exhaust inlet
and 3" v-band outlet (external gate only.. none of that internal gate turbulent nonsense!)

This week i will be putting the compressor housing back onto the lather to clean up the casting inside of the 4" surge ported snout.
Will also be polishing the housings outlet, and general clean up of the outer casing before powdercoat.

Turbine housing I will be lathing down each of the bolts holding it to the CHRA.
They are all slightly too long and intruding into one side of the turbine port.

All of this should equal.... probably close to Zero results... But i don't like it the way it is, and i would like to fix up the imperfections as made by Garrett... well Honeywell... aka some factory in Mexico before it gets bolted to the new engine.

Will upload some photos of the set up over the weekend
__________________

1994 323 BG Hatch 2005-2007 Crashed into truck
1991 323 BG Hatch 2007-2008/9 SOLD
2003 BJ SP20 J48 Hatch 2008-2011 Regretfully SOLD
1997 BA I4 Sedan 2012-CURRENT
1985 BF 323 Hatch 2014-2015
SOLD
1989 MX5 2015-2015
Mad Mat is offline   Reply With Quote