Thread
:
bjII protege 1.8 tree hugger
View Single Post
14-01-2012, 07:46 AM
#
5
JDM323
Senior Member
Join Date: May 2011
Location: North Qld
Car: 2002 BJ2 protege
Posts: 1,241
while the bar was off i fitted 3000k hid's to the fog lights and made a new fog light harness to go directly to the ballasts and ran the wiring on the body and re fitted the bumper using sag fix brackets instead of the nut+bolts i had been fighting with
the tail lights were next for these the chrome rings were routered down as much as practical using jigs made from 38mm chipboard on a cnc machine, the lower lenses were also trimmed down and custom led assemblies fitted, the stop/tail was already led but in the center which was the indicator was fitted with an e-mark reflector the lenses were lightly tinted then the lights were re assembled and fitted to the car, at the same time i fitted led bulbs to the front indicators which required a pin swap on the plugs and load resistors wired in.
the load resistors were fitted in the rear, 2 on each side keeping them out of the engine bay.
from this to this
Last edited by JDM323; 06-12-2014 at
04:17 PM
.
JDM323
View Public Profile
Send a private message to JDM323
Find More Posts by JDM323