View Single Post
Old 26-02-2012, 04:17 PM   #6
derb
Senior Member
 
derb's Avatar
 
Join Date: Oct 2008
Location: Brisbane
Car: 1993 BG Astina GT-X
Posts: 1,822
I finally got around to spraying and installing my dump pipe heat shield. Now I have full set and they don't look too bad in the engine bay if you ask me. When fitting the dump shield I noticed a wet lower rad pipe. Turned out the engine side clamp had failed/threaded itself at some point. So I had to dump out a pretty fresh load Redline Water Wetter. And since Burson's were closed I had to get Tectaloy. At least I found it now and not up a mountain somewhere.

I also fitted the oil catch can I've had sitting around for a few weeks. The setup going into the factory intake isn't the nicest thing you'll see, but it works. And it's not entirely useless since I have noticed a bit of blow by in the intake pipe.





derb is offline   Reply With Quote