Thread: Ghe770
View Single Post
Old 07-12-2013, 08:39 PM   #30
ghetto3
Senior Member
 
ghetto3's Avatar
 
Join Date: Sep 2011
Location: north coast nsw
Car: 97 ba 1.8 323
Posts: 799
The build is progressing slowly, spending time gathering parts, wiring/painting and fixing up all the little stuff like fuel lines etc.
Ive rearranged alot of the wiring and gotten rid of a heap of uneeded circuits in the process. The whole car is pretty raw so i kept the theme going with the rewire, stripping the entire loom from the car and then reusing/replacing only what i need.

I've changed it again since this pic by placing bus bars and circuit breakers in an ip65 sealed box to neeten it up a bit.
The EWP controller directs both the water pump and the two rad. fans exclusively. The flasher unit is top right, the two lower fuse boxes are acc./ign.1 and ign.2. Auto reset circuit breakers are used on crucial circuits like headlights to stop intermittent shorts taking out the lights at inconvenient times. It needs cleaning up and then im onto the ecu wire in for
real (measured fifty odd times, about to
cut once i hope)

Last edited by ghetto3; 07-12-2013 at 08:42 PM.
ghetto3 is offline   Reply With Quote