Ok, so these are the completed prototypes for the Passenger Side Engine Mount and the Driver's Side Transmission Mount. The fitment on the passenger side mount took a little bit of hammering of the body to get it to bolt down, but nothing too extreme. The driver's side mount bolted down with no trouble at all AND the tappered bracket that is inserted into it fits PERFECTLY now.
The only problem is that I've had difficulties receiving updates from Tony from AWR. I called him about a week ago and he's been having trouble with the laser cutter he used locating both sets of the front and rear prototypes, which means I can't test fit the entire set to make sure they all play nice with each other. I'll try giving Tony a ring tomorrow and see where I'm standing at with this.
P.S. Thank god I got a new camera again.
P.P.S I suck at life for not updating this earlier, so my apologies for that