Quote:
|
Originally Posted by DMS
Any news on this?
|
Yes
An Update.
New Trans should be ready mid next week.
Engine Timed and Assembled.
You can see my solution to squeaking aluminum pulley on startup.... Small lines were machined into the ridges at equal spacing
You can also see how I set and check the engine to "Top Dead Center" with two socket extensions in cylinder
#1
Decided to install the hood latches thus
removing the stock hood latch, which made the Sexy CR3 "Hole Less" diverter plate possible.
Added Cabinets to the Garage..
Baller!
