View Single Post
Old 05-10-2011, 07:53 PM   #61
jesiotrot
Junior Member
 
jesiotrot's Avatar
 
Join Date: Aug 2007
Location: Melbourne
Car: MX6 Capella Infini
Posts: 65
Have they checked and rechecked the cam timing? Maybe they put the belt a few teeth out on one cam, that would cause a similar issue.

You should not be mixing and matching electrical and injection parts, just use all of your original ones. If its running lean use a fuel pressure reg to up the fuel pressure. The injectors between FP and FS may run different impedance, especially if they were built in different years or series car, the ecu will not be able to control injectors with an impedance that varies too far from stock ones.
jesiotrot is offline   Reply With Quote