Go Back   AstinaGT Forums

1990 MX6GT F2T 12v 2.2l turbo manual

boostedbatman’s AstinaGT Forums Photo Gallery
1990 MX6GT F2T 12v 2.2l turbo manual

1990 MX6 GT 2 door
2.2l 12v turbo
Gates Timing Belt
NGK Iridium Spark Plugs
9mm Ignition Leads
CAMSHAFT: 272 deg 10.5mm lift(int & exh)
Hotshot Pod Air Filter
Turbosmart Type II BOV
2.5" Dump Pipe
Full 3" Exhaust
Turbo Timer

Fidanza 10lb Aluminium Flywheel
Exedy Button Cushion Clutch
Stainless Steel Clutch Flexi-Line
Short shifter (very short with Bat spec poly bush kit)Dot 6 fluid (RBF600)

JIC SA-1 Fully Adjustable Coilovers with height and damper control and pillowball tops(FR:9kg, R:7kg springs)
Whiteline 22mm Front Swaybar
Whiteline 20mm Rear Swaybar
Whiteline Adjustable Rear Swaybar Endlinks(with polyurethane bushes) Shortened
Whiteline Adjustable Front Swaybar Endlinks(with polyurethane bushes) Shortened
Whiteline Rear Strut Brace
Whiteline Front Strut Brace
All Rubber Bushes replaced with Polyurethane Bushes(Front Control Arms, Rear Trailing Arms, Lateral Links)

V6 Astina Brake Calipers (RX7 4 piston still to be installed)
Upgraded to larger 276mm RDA Slotted Rotors-Front
________________250mm RDA Slotted Rotors-Rear
Lucas Brake Pads
Stainless Steel Brake Lines
Dot 6 Fluid (RBF 600)

Nissan S15 Rims (Matt Black)
Federal 535S 2055016 Tyres

Momocorse FIA Approved Race Seat
Megasquirt IIv3.0
Ford EDIS (Electronic Distributorless Ignition System)
4x Bosch Ignition Coils
AEM Wideband O2 Sensor
AEM Fuel Pressure Regulator
Garrett GT30 Turbo(awaiting manifold)
Tial 38mm Wastegate
Toyota 4AGE Blacktop Quad Throttle setup (Need to build manifold and Plenum)

ALSO: Negotiations are currently underway into custom bolt in Steampipe Turbo Manifold, Intercooler and Plumbing
Then drop in some straight fit Toyota 7MGTE injectors
And a nice Bosch044 fuel pump

It does need some TLC in the body department But...

Click Thumbnail to Enlarge.
mmm one FATT cam Exedy Clutch Fidanza Flywheel Front Right Major Improvements Garrett GT30 Front Left Rear Left Side Right
Gallery Statistics
Member: boostedbatman
Created: 23-08-2007 07:23 AM
Last Modified: 07-09-2007 06:35 PM
Views: 3816
Images: 8
Comments: 15

Author Comment Date
bourbon you can have a look when i come back to yours to give ya stuff back and to pick up my nice little present wont be going in for a little while though... 08-09-2007
boostedbatman Yes they are S15 Rims, didnt realise I mucked that up, oops my bad

It will be raced when timing is right Ryan
Dont rush me son for youre only gonna see the rear end anyway

If your cam looks like that Nath then youve got some good metal there
bourbon also i had a quick look in my engine the other day the cam shaft looked simular to yours batty will try and take some piccies when its up and going 28-08-2007
project.r.racing It does need some TLC in the body department But...

I suggest racing it!
marcs_sp20 arent they S15 rims? 27-08-2007
boostedbatman It suits my Dark Side 27-08-2007
project.r.racing I really luv the black rims also!!! 26-08-2007
boostedbatman And some buckets of rust that dont............................. 25-08-2007
bourbon DAN IS KEEN ON ANYTHIN THAT MOVES... 24-08-2007
boostedbatman Didnt know you were that keen on it Mr D! 24-08-2007
Rupewrecht About time you posted it up! 24-08-2007
boostedbatman HeHe I knew you'd like it 23-08-2007
project.r.racing NICE!!! 23-08-2007
boostedbatman Wont know power figures till after engine management is wired up, Im just a bit lazy atm (surprise, surprise). Thinking of leaving it till after the GT30 goes on.
And this is not pretty, its a real dunga till it gets a spray
marcs_sp20 How much power does it put down pete? very nice, just needs a nice paint job to finish it off One of my mates from school has one of these in blueprint blue, tis very pretty 23-08-2007
Powered by: vBPicGallery

All times are GMT +10. The time now is 11:31 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.
2001- 2010 AstinaGT